LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 725 (Door System, Mirror System & Window System) >> Repair Instructions >> Wiring Harness Replacement - Door >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the hinge pillar trim panel. Refer to TRIM PANEL REPLACEMENT - HINGE PILLAR .
    2. Fig 1: Cross Car Wiring Harness
    GM375036Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the cross car wiring harness.
  3. Remove the conduit.
  4. Remove the upper trim panel extension. Refer to Trim Panel Replacement - Upper Extension .
  5. Remove the trim panel. Refer to Trim Panel Replacement - Side Front Door .
  6. Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
    7. Fig 2: Door Wiring Harness Components
    GM375037Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the following components:
    • The outside power mirror (1)
    • C203 (4)
    • P500 (5)
    • The speaker (6)
    • The power window motor (7)
    • The power lock switch (8)
    • The power window switch (9)
    • The power mirror switch (10)
    • The door lock actuator
  8. Remove the door wiring harness from the door by pulling the harness through the conduit (3).
scientia non olet · About LEMON Manuals