LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 725 (Door System, Mirror System & Window System) >> Repair Instructions >> Window Replacement - Rear Door (Tahoe/Yukon/Escalade) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Door Window (Tahoe/Yukon/Escalade)
    GM739350Courtesy of GENERAL MOTORS CORP.
  1. Partially raise the window.
  2. Remove the manual door-lock lever.
  3. Remove the manual window handle, if equipped. Refer to Window Handle Replacement .
  4. Remove the power accessory switch panel. Refer to Power Accessory Switch Panel Replacement .
  5. Remove the door trim panel. Refer to Trim Panel Replacement - Side Rear Door (Tahoe/Yukon/Escalade)  or Trim Panel Replacement - Side Rear Door (Suburban/Yukon XL/Avalanche/Escld EXT) .
  6. Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
  7. Loosen the window run channel bolt.
    8. IMPORTANT: Do not remove the bolt.
  8. Loosen the retaining bolts (3) from the window assembly.
  9. Remove the window glass (1) from the door by sliding the window glass out through the top.
scientia non olet · About LEMON Manuals