LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 725 (Door System, Mirror System & Window System) >> Repair Instructions >> Trim Panel Replacement - Side Rear Door (Tahoe/Yukon/Escalade) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the door handle bezel. Refer to Handle Bezel Replacement - Inside .
  2. Remove the window-regulator handle, if equipped. Refer to Window Handle Replacement .
  3. Remove the manual lock lever from the trim panel using a flat-bladed tool.
    4. Fig 1: Side Rear Door Trim Panel (Tahoe/Yukon/Escalade)
    GM521847Courtesy of GENERAL MOTORS CORP.
  4. Remove the trim panel screws.
  5. In order to remove the trim panel, slide the trim panel upward and outward in order to release the trim panel tab retainers.
  6. Disconnect the electrical connectors, if necessary.
scientia non olet · About LEMON Manuals