LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 725 (Door System, Mirror System & Window System) >> Repair Instructions >> Module Replacement - Rear Power Window (Suburban/Yukon XL/Avalanche/Escld Ext) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trim panel. Refer to Trim Panel Replacement - Side Rear Door (Tahoe/Yukon/Escalade)  or Trim Panel Replacement - Side Rear Door (Suburban/Yukon XL/Avalanche/Escld EXT) .
  2. Remove the water deflector. Refer to Water Deflector Replacement - Rear Door (Tahoe/Yukon/Escalade)  or Water Deflector Replacement - Rear Door (Suburban/Yukon XL/Avalanche/Escld EXT) .
  3. Remove the window glass. Refer to Window Replacement - Rear Door (Tahoe/Yukon/Escalade)  or Window Replacement - Rear Door (Suburban/Yukon XL/Avalanche/Escld Ext) .
  4. Remove the window sash.
  5. Remove the glass weatherstrip.
    6. Fig 1: Rear Power Window Module (Suburban/Yukon XL/Avalanche/Escld Ext)
    GM581730Courtesy of GENERAL MOTORS CORP.
  6. Remove the module from the door.
scientia non olet · About LEMON Manuals