LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 725 (Door System, Mirror System & Window System) >> Repair Instructions >> Lock Actuator Replacement - Front Door >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the window glass.
  2. Remove the door trim panel. Refer to Trim Panel Replacement - Side Front Door .
  3. Remove the water deflector. Refer to Water Deflector Replacement - Front Door .
    4. Fig 1: View Of Control Rod To Inside Door Handle
    GM348468Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the inside door lock rod from the handle retainer clip.
    5. Fig 2: Manual Door Lock Rod & Door Retainer Clips
    GM348465Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the manual door lock rod from the door retainer clips.
    6. Fig 3: Rubber Plug (Front Door)
    GM800623Courtesy of GENERAL MOTORS CORP.
  6. Remove the rubber plug (1) in order to disengage the outside handle rod retainer.
    7. Fig 4: Cylinder Lock Rod & Door Lock Actuator Bolt
    GM800627Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the cylinder lock rod (1).
  8. Remove the bolts (2) which retain the door lock actuator to the door.
  9. Remove the door lock actuator and the control rods as an assembly.
  10. Disconnect the electrical connector from the door lock actuator, if equipped.
  11. Remove the control rods as necessary.
scientia non olet · About LEMON Manuals