LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 725 (Door System, Mirror System & Window System) >> Diagnostic Information and Procedures >> Automatic Door Locks Inoperative (Automatic Transmission)

Automatic Door Locks Inoperative (Automatic Transmission)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Automatic Door Locks Inoperative (Automatic Transmission)

Step Action Yes No
Schematic Reference: Door Lock/Indicator Schematics 
IMPORTANT: The automatic door lock system can be programed to perform different functions and may also be disabled. Before continuing with the diagnosis of the system, ensure that the automatic door locks are programmed to perform the specific function that is the cause of the complaint. For further information, refer to VEHICLE PERSONALIZATION .
1 Did you perform the Door Systems Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Door Systems 
2 Lock and unlock the doors from any of the door lock switches.
Does the door lock system function properly?		 Go to Step 3  Go to Symptoms - Doors 
3
  1. Install the scan tool.
  2. Using output controls, command the doors to lock and unlock.
Do the doors lock and unlock when commanded?		 Go to Step 4  Go to Step 5 
4
  1. Start the engine.
  2. Using the scan tool, monitor the TR Sw. data parameter in the transmission data display table.
  3. Place the transmission in all gear ranges while monitoring the scan tool.
Does the scan tool display the correct data parameter values?		 Go to Step 6  Go to DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS for 4.8L, 5.3L and 6.0L or DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS for 8.1L.
5 Test for an open in the door lock and door unlock control circuits. Refer to CIRCUIT TESTING and WIRING REPAIRS .
Did you find and correct the condition?		 Go to Step 8  Go to Step 6 
6 Inspect for poor connections at the BCM harness connectors. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS and CONNECTOR REPAIRS .
Did you find and correct the condition?		 Go to Step 8  Go to Step 6 
7
IMPORTANT: Perform the setup procedure for the body control module.
Replace the body control module. Refer to BODY CONTROL MODULE REPLACEMENT .Did you complete the repair?		 Go to Step 8  -
8 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals