LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 721 (Engine Mechanical - 8.1L (On-Vehicle)) >> Repair Instructions >> Drive Belt Replacement - Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: A/C Belt Tensioner
    GM370869Courtesy of GENERAL MOTORS CORP.
  1. Install the A/C belt around the crankshaft balancer.
  2. Install the breaker bar into the A/C drive belt tensioner adapter opening
  3. Rotate the A/C belt tensioner clockwise in order to relieve tension on the tensioner.
  4. Install the A/C belt over the idler pulley.
  5. Install the A/C belt around the A/C compressor pulley.
  6. Slowly release the tension on the A/C belt tensioner.
  7. Remove the breaker bar from the A/C belt tensioner.
  8. Inspect the A/C belt for proper installation and alignment.
  9. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
scientia non olet · About LEMON Manuals