LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 721 (Engine Mechanical - 8.1L (On-Vehicle)) >> Repair Instructions >> Drive Belt Replacement - Accessory >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Drive Belt Routing - Accessory
    GM750183Courtesy of GENERAL MOTORS CORP.
  1. Install a breaker bar with hex-head socket to the drive belt tensioner bolt.
  2. Rotate the drive belt tensioner clockwise in order to relieve tension on the belt.
  3. Remove the belt from the pulleys and the drive belt tensioner.
  4. Slowly release the tension on the drive belt tensioner.
  5. Remove the breaker bar and socket and from the drive belt tensioner bolt.
  6. Clean and inspect the belt surfaces of all the pulleys.
scientia non olet · About LEMON Manuals