LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 721 (Engine Mechanical - 8.1L (On-Vehicle)) >> Repair Instructions >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Yukon XL, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Belt Idler Pulley
    GM678804Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the drive belt idler pulley and bolt to the generator bracket.

    Snug the bolt finger tight.

  2. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .

    Tighten:  Tighten the drive belt idler pulley bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals