LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 719 (Power Seat System) >> Repair Instructions >> Seat Cushion Cover & Pad Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat cushion cover to the foam pad.
  2. Install the center screw retaining the latch cover, if removed. Tighten the screw to 2 N.m (18 lb in).
  3. Engage the hook, and the loop-strips that are retaining the seat cushion cover (3) to the foam pad (4).
  4. Install the seat buckles, if removed. Refer to SEAT BELT BUCKLE AND LATCH REPLACEMENT - REAR (EXTENDED CAB) or SEAT BELT BUCKLE AND LATCH REPLACEMENT REAR (CREW CAB) .
  5. Connect the rear heater connector, if equipped.
  6. Install the hog rings, and/or the J-clips in order to retain the seat cushion cover to the seat cushion frame (8).
  7. Install the rear passenger seat risers.
  8. Install the rear seat to the vehicle. Refer to Seat Replacement - Rear (Extended Cab w/4th Door) , Seat Replacement - Rear (Extended Cab)  or Seat Replacement - Rear (60/40 Split)  .
scientia non olet · About LEMON Manuals