LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 719 (Power Seat System) >> Repair Instructions >> Seat Back Hinge/Recliner Mechanism Replace - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the recliner cable to the recliner mechanism.
  2. Install the drive cable, if equipped with a power recliner.
  3. Install the U-channel (1).
  4. Install the recliner screw (5). Tighten the screw to 10 N.m (89 lb in).
  5. Install the front recliner attachment bolts (4). Tighten the bolts to 53 N.m (39 lb ft).
  6. Attach the recliner cable (1) to the folding mechanism (3).
  7. Attach the bolts holding the seat back folding mechanism. Tighten the bolts to 21 N.m (15 lb ft).
  8. Install the outboard pivot bolt. Tighten the bolt to 35 N.m (26 lb ft).
  9. Install the seat back frame. Refer to Seat Back Frame Replacement - Front .
  10. Install the seat cushion frame. Refer to Seat Cushion Frame Replacement - Front .
  11. Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  12. Install the front seat in the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals