LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 719 (Power Seat System) >> Repair Instructions >> Seat Back Cover & Pad Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the foam pad to the frame.
  2. Install the seat belt tower.
  3. Install the bolts which retain the seat belt tower cover. Tighten the bolts to 1.9 N.m (17 lb in).
  4. Install the rear cardboard panel. Engage the panel fasteners.
  5. Install the seat back cover partially onto the top of the frame.
  6. Feed the seat belt and the seat belt bezel through the tower opening.
  7. Install the arm rest clip.
  8. Pull the rest of the cover down using a side-to-side motion.
  9. Install the armrests, if equipped. Refer to Armrest Replacement - Front Seat .
  10. Install the head restraint retainers. Refer to Head Restraint Retainer Replacement - Front Seat .
  11. Fit the seat cover around the air bag cover.
  12. Pull the seat belt down through the seat cushion and install the outboard seat belt anchor nut. Tighten the nut to 53 N.m (39 lb ft).
  13. Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  14. Install the head restraints. Refer to Head Restraint Replacement .
  15. Push on the seat cover. Ensure that the cover is retained by the velcro in the seat cushion.
  16. Connect the J-strip at the bottom of the seat.
  17. If equipped with side air bags, enable the air bag module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals