LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 716 (Exterior Trim) >> Repair Instructions >> Wheel Opening Flare Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Install in an environment that is free from dust or dirt. Dust and dirt could come in contact with the adhesive surface and prevent proper adhesion.

  1. Clean the area where the wheel opening flare is to be mounted. Use a suitable solvent, such as flash naphtha or a mixture of 50 percent isopropyl alcohol and 50 percent water.
  2. Dry the area thoroughly.
  3. Warm the body panel with a heat gun J 25070. 

    Important:  Do not touch the adhesive surface when the tape is removed.

  4. Remove the adhesive tape from the wheel opening flare.
  5. Install the wheel opening flare to the front fender.
  6. Install the push pins to retain the wheel opening flare.
scientia non olet · About LEMON Manuals