LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 716 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Roof Joint (Extended Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Preheat the sheet metal in order to melt the sealer and bond the molding into the joint. Sealer begins to flow at approximately 93°C (200°F).

  1. Use the J 25070  in order to heat the cab in the joint area. Preheat the sheet metal to approximately 93°C (200°F).
  2. Install the molding.
scientia non olet · About LEMON Manuals