LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 711 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Center Console End Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power outlets to the end panel, if equipped.
  2. Install the console floor lamp, if equipped.
  3. Install the rear seat audio controls, if equipped.
  4. Install the rear seat heater switch, if equipped.
  5. Connect all electrical connectors.
  6. Install the end panel to the console.
  7. Install the 2 top retaining screws (1). Tighten the screws to 1.6 N.m (14 lb in).
  8. Install the 4 retaining screws (1). Tighten the screws to 1.6 N.m (14 lb in).
  9. Install the rear cupholder to the end panel.
  10. Install the storage bin. Refer to Console Storage Bin Replacement (Non-Luxury) , Console Storage Bin Replacement (Luxury) , or Console Storage Bin Replacement (Pro)  .
scientia non olet · About LEMON Manuals