LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 702 (Exterior Trim) >> Repair Instructions >> Molding Repair >> Adhesive Body Side Moldings End Loose

Adhesive Body Side Moldings End Loose

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wash the affected area with soap and water and wipe dry. Wipe the panel and the adhesive side of the molding with a clean rag using oil-free naphtha or alcohol.
  2. If needed, apply a length of masking tape as a molding guide. A straightedge may also be used.
  3. Apply the adhesive to the back of the molding and press in place. If the adhesive GM P/N 1052621 or equivalent is used, apply constant pressure to the molding for 30 seconds or until a firm bond has been made.
scientia non olet · About LEMON Manuals