Conditions For Running DTC P0752

WARNING: This page is about a different car, the 2002 GMC Cab & Chassis Sierra and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

DTC will run under the following conditions:

No MAP sensor DTCs P0106, P0107 or P0108.
No MAF sensor DTCs P0101, P0102, or P0103.
No TP sensor DTCs P0121, P0122, P0123, P1120, P1220 or P1221.
No ISS DTCs P0716 or P0717.
No OSS DTCs P0502 or P0503.
No TFP manual valve position switch DTC P1810.
No TCC PWM solenoid valve DTC P1860.
No transmission component slipping DTC P1870.
No TCC stuck on DTC P0742.
The system voltage is 10-18 volts.
The engine must be running more than 400 RPM for 7 seconds.
The vehicle speed is greater than 7 MPH.
The throttle angle is greater than 10 percent.
No transmission component slipping DTC P1870.
The engine torque must be between 80 ft. lbs. (108 N.m) and 650 ft. lbs. (881 N.m).
No TFP manual valve position switch change within 6 seconds.
The TFP manual valve position switch indicates "D4".
The transmission fluid temperature is greater than 68°F (20°C).