LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Brake Caliper >> Installation

Rear Brake Caliper: Installation

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 1999 Pontiac Montana, 1999 Oldsmobile Silhouette, 1999 Oldsmobile Bravada, 1999 GMC Yukon, and 1999 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean corrosion from machined ways on caliper and caliper mount. Apply silicone grease to these surfaces. Install inner pad and anti-rattle spring on caliper mount. Install outer pad in caliper. Install caliper.
  2. Install caliper support key and spring. Install caliper support key bolt, ensuring bolt boss fits into circular cutout on caliper support key. Tighten to specification. See TORQUE SPECIFICATIONS .
  3. Connect brake hose to caliper and tighten hose bolt to specification. See TORQUE SPECIFICATIONS . Bleed brake system. See MANUAL BLEEDING  or PRESSURE BLEEDING  under BLEEDING BRAKE SYSTEM. Install wheel.
scientia non olet · About LEMON Manuals