Brake Shoe Assembly
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 1999 Pontiac Montana, 1999 Oldsmobile Silhouette, 1999 Oldsmobile Bravada, 1999 GMC Yukon, and 1999 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
Some "C" , "K" and "U" series vehicles are equipped with leading/trailing brakes, identified by adjuster screw hole in backing plate, located above horizontal centerline of rear axle. All other models are equipped with dual-servo brakes, identified by adjuster screw hole at bottom of backing plate.
Brake assembly consists of backing plate, brake shoes, return springs, automatic adjusting assembly and a wheel cylinder. Automatic adjusting assembly consists of an actuator lever, return spring, actuator link, adjusting screw and spring. Automatic adjustment is accomplished through movement of actuating lever and secondary shoe.