LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 699 (Wiper System And Washer System) >> Diagnostic Information And Procedures >> Wiper Arm Tip Pressure Check

Wiper Arm Tip Pressure Check

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Run the wiper arms to the mid-wipe position.
  2. Remove the wiper blades from the wiper arms. Refer to Wiper Arm Blade Replacement  .
  3. Attach a scale to the end of the wiper arm and measure the force required to lift the wiper arm perpendicular to the windshield to normal working height (height with the blade attached).
    4. Fig 1: Measuring Force Required To Lift Wiper Arm Perpendicular
    G01800996Courtesy of GENERAL MOTORS CORP.
  4. Replace the wiper arm if the measurement is not within the specification. Refer to Wiper Arm Replacement  .

    Tip Pressure 

    9-11 Newtons (32-40 Ounces)

scientia non olet · About LEMON Manuals