Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.

From the rear compartment, feed the rear seat center shoulder belt and escutcheon through opening in the rear shelf trim panel.
Install the retractor to the cross brace.
Carefully lift upward on the rear shelf trim panel.
CAUTION: Refer to FASTENER NOTICE .
From inside the vehicle, install the rear seat center shoulder retractor fastener (2).
Tighten

Tighten the rear seat center shoulder belt retractor fastener (2) to 30 N.m (22 lb ft).
Install the push-in fastener (1) in order to secure the rear shelf trim panel.

Fig 1: Installing Retractor Fastener
Courtesy of GENERAL MOTORS CORP.
Install the rear seat center belt escutcheon to the rear shelf opening.

Fig 2: Installing Rear Seat Center Belt Escutcheon
Courtesy of GENERAL MOTORS CORP.
Install the rear seat back. Refer to SEAT BACK REPLACEMENT -- REAR .
Important: Ensure that the fastener threads and fastener hole are free of any sealer patch material.
Install the rear center seat belt lower fastener.

Fig 3: Installing Rear center Seat Belt Lower Fastener

Courtesy of GENERAL MOTORS CORP.

Ensure the seat belt anchor is facing forward and the seat belt is not twisted.
Tighten

Tighten the rear center seat belt lower fastener to 41 N.m (30 lb ft).
Install the rear compartment front trim. Refer to COMPARTMENT TRIM PANEL REPLACEMENT--REAR in Body Rear End.
Install the rear seat cushion. Refer to SEAT CUSHION REPLACEMENT -- REAR .