Conditions For Running DTC P1810
WARNING: This page is about a different car, the 2002 GMC Cab & Chassis Sierra and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
DTC will run under the following conditions:
- No VSS DTCs P0502 or P0503.
- No ISS DTCs P0716 or P0717.
- No TFP manual valve position switch DTC P1810.
- No MAP DTCs P0106, P0107 or P0108.
- No 1-2 shift solenoid DTCs P0751 or P0753.
- No 2-3 shift solenoid DTCs P0756 or P0758.
- The engine speed is greater than 475 RPM for greater than 7 seconds.
- The system voltage is 8-18 volts.
- The accelerator pedal position angle is greater than 12 percent.
- The engine speed is less than 3750.
- Not in fuel cut-off.
- The engine torque is 80-475 ft. lbs. (108-644 N.m).
- The engine vacuum is 0-15 psi (0-1.05 kg/cm2 ).