LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 689 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Column Trim Covers Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the closeout shroud to the upper steering column trim cover.
    CAUTION: Refer to FASTENER NOTICE .
  2. Install the upper steering column trim cover retaining screw.

    Tighten 

    Tighten the upper steering column trim cover retaining screw to 1.5 N.m (13 lb in).

    Fig 1: Installing Upper Steering Column Trim Cover
    G01581830Courtesy of GENERAL MOTORS CORP.
  3. Connect the closeout shroud to the lower steering column trim cover.
  4. Install the lower steering column trim cover retaining screws.

    Tighten 

    Tighten the lower steering column trim cover retaining screws to 3.5 N.m (31 lb in).

    Fig 2: Installing Lower steering Column Trim Cover
    G01581831Courtesy of GENERAL MOTORS CORP.
  5. Install the tilt lever.
    6. Fig 3: Installing Tilt Lever
    G01581832Courtesy of GENERAL MOTORS CORP.
  6. Install the knee bolster. Refer to KNEE BOLSTER REPLACEMENT .
  7. Install the steering wheel. Refer to Steering Wheel Replacement  .
  8. Enable the SIR system. Refer to ACTIVATING SYSTEM .
scientia non olet · About LEMON Manuals