LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Seat Cushion Trim Cover and Pad Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
    2. Fig 1: Removing Seat Belt Anchor Nut
    GM381493Courtesy of GENERAL MOTORS CORP.
  2. Remove the outboard seat belt anchor nut. Pull the belt through the seat cushion.
    3. Fig 2: View Of Seat Cushion Front Nuts & Rear Plastic Holders
    GM378531Courtesy of GENERAL MOTORS CORP.
  3. Remove the front nuts (2) on the underside of the seat cushion.
    4. Fig 3: View Of Lumbar Cable And Front Seat Cushion Frame Components
    GM407184Courtesy of GENERAL MOTORS CORP.
  4. Unsnap the lumbar cable (6) (disconnect the lumbar wire harness if equipped with power lumbar).
  5. Disconnect the electrical connectors.
    6. Fig 4: View Of Seat Cushion Front Nuts & Rear Plastic Holders
    GM378531Courtesy of GENERAL MOTORS CORP.
  6. Lift the seat cushion up off the rear plastic holders (1) on the underside of the seat cushion, and pull forward.
  7. Remove the seat switch bezel. Refer to Seat Switch Bezel Replacement .
    8. Fig 5: View Of Lumbar Cable And Front Seat Cushion Frame Components
    GM407184Courtesy of GENERAL MOTORS CORP.
  8. Remove the lumbar actuator (5).
    9. Fig 6: Unclipping Seat Trim Cover From Seat Cushion Frame
    GM386197Courtesy of GENERAL MOTORS CORP.
  9. Unclip the seat trim cover from the seat cushion frame.
    10. Fig 7: Separating Seat Cushion Trim Cover From Pad
    GM386196Courtesy of GENERAL MOTORS CORP.
  10. Using a side motion, carefully separate the seat cushion trim cover from the seat cushion pad.
  11. Remove the pad from the seat cushion frame.
  12. Remove the seat cushion heater element, if equipped. Refer to Seat Cushion Heater Element Replacement - Front .
scientia non olet · About LEMON Manuals