LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Seat Back Latch Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat from the vehicle. Refer to Seat Replacement - Rear (60/40 Split)  or Seat Replacement - Rear (50/50 Split 2nd Rear) .
    Fig 1: Removing Bolts & Screw Retaining Latch Assembly To Seat Frame
    GM788614Courtesy of GENERAL MOTORS CORP.
  2. Remove the armrest, if equipped. Refer to Armrest Replacement - Rear Seat (60/40 - 50/50 Split)  or Armrest Replacement - Rear Seat (Bucket) .
  3. Remove the seat back cover. Refer to Seat Back Cover and Pad Replacement - Rear (60/40 - 50/50 Split)  or Seat Back Cover and Pad Replacement - Rear (Bench) .
  4. Remove the bolts (1,2) that retain the latch assembly to the seat frame.
  5. Remove the screw (3) that retains the latch assembly to the seat frame.
  6. Unsnap the recliner cables from the folding mechanism.
  7. Remove the seat back latch assembly from the seat frame.
    8. Fig 2: Removing Seat Belt Guide & Spacer
    GM814964Courtesy of GENERAL MOTORS CORP.
  8. Remove the spacer (2) from the latch assembly, if equipped.
  9. Remove the seat belt guide (1) from the latch assembly, if equipped.
scientia non olet · About LEMON Manuals