LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Seat Back Frame Replacement - Rear (60/40 - 50/50 Split) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Seat Back Frame (60/40 - 50/50 Split)
    GM276335Courtesy of GENERAL MOTORS CORP.
  1. Install the seat-back frame (4) to the seat cushion frame.
    2. NOTE: Refer to FASTENER NOTICE
  2. Install the bolts which retain the seat-back frame to the seat cushion frame.

    Tighten:  Tighten to 35 N.m (26 lb ft).

  3. Install the seat-back cover. Refer to Seat Back Cover and Pad Replacement - Rear (60/40 - 50/50 Split)  or Seat Back Cover and Pad Replacement - Rear (Bench) .
  4. Install the armrest to the seat back. Refer to Armrest Replacement - Rear Seat (60/40 - 50/50 Split)  or Armrest Replacement - Rear Seat (Bucket) .
  5. Install the seat to the vehicle. Refer to Seat Replacement - Rear (60/40 Split)  or Seat Replacement - Rear (50/50 Split 2nd Rear) .
scientia non olet · About LEMON Manuals