LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear (Bench) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seat from the vehicle. Refer to Seat Replacement - Rear Bench .
  2. Remove the headrests. Refer to Head Restraint Replacement (Non-Cadillac)  or Head Restraint Replacement (Cadillac)  or Head Restraint Replacement (Folding) .
  3. Remove the side trim plate and screws (1).
    Fig 1: Side Trim Plate & Screws
    GM841667Courtesy of GENERAL MOTORS CORP.
    4. Fig 2: Seat Belt Anchor Bolt
    GM841672Courtesy of GENERAL MOTORS CORP.
  4. Remove the seat belt anchor bolt (1).
    5. Fig 3: Plastic Seat Belt Guides
    GM841675Courtesy of GENERAL MOTORS CORP.
  5. Remove the plastic seat belt guides (1).
    6. Fig 4: Removing Plastic Pushpin
    GM841679Courtesy of GENERAL MOTORS CORP.
  6. Release the J-Clips from the trim.
  7. Remove the plastic pushpin (1) from the side seat belt guide.
  8. Remove the head restraint retainers.
  9. Remove the seat back cover and pad from the frame.
scientia non olet · About LEMON Manuals