LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Rear (Bench) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat back cover and pad to the frame.
  2. Install the head restraint retainers.
  3. Install the plastic pushpin (1) into the side seat belt guide.
    Fig 1: Installing Plastic Pushpin
    GM841679Courtesy of GENERAL MOTORS CORP.
    4. Fig 2: Plastic Seat Belt Guides
    GM841675Courtesy of GENERAL MOTORS CORP.
  4. Connect the J-Clips to the trim.
  5. Install the plastic seat belt guides (1).
    6. Fig 3: Seat Belt Anchor Bolt
    GM841672Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  6. Install the seat belt anchor bolt (1).

    Tighten:  Tighten the bolt to 53 N.m (39 lbs ft)

    7. Fig 4: Installing Side Trim Plate & Screws
    GM841667Courtesy of GENERAL MOTORS CORP.
  7. Install the side trim plate and screws (1).

    Tighten:  Tighten the screw to 2 N.m (18 lbs in)

  8. Install the headrests. Refer to Head Restraint Replacement (Non-Cadillac)  or Head Restraint Replacement (Cadillac)  or Head Restraint Replacement (Folding) .
  9. Install the seat to the vehicle. Refer to Seat Replacement - Rear Bench .
scientia non olet · About LEMON Manuals