LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped with side air bags, disable the air bag module. Refer to DISABLING SYSTEM .
  2. Remove the head restraint. Refer to Head Restraint Replacement (Non-Cadillac)  or Head Restraint Replacement (Cadillac)  or Head Restraint Replacement (Folding) .
  3. Remove the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
    4. Fig 1: Removing Outboard Seat Belt Anchor Nut
    GM381493Courtesy of GENERAL MOTORS CORP.
  4. Remove the outboard seat belt anchor nut. Pull the seat belt through the seat cushion.
  5. Disengage the J-strip retainer on the bottom of the seat back cover.
  6. Disconnect the heater seat element connector, if equipped.
    7. Fig 2: Removing Seat Back Cover
    GM381479Courtesy of GENERAL MOTORS CORP.
  7. Using a side motion, carefully lift the seat back cover partially off the foam pad in order to access the arm rest clip.
  8. Remove the armrest, if equipped. Refer to Armrest Replacement - Front Seat .
  9. Using a flat bladed tool lift the seat cover over the air bag cover.
  10. Remove the seat cover to the top of the seat.
    11. Fig 3: View Of Seat Belt Tower Cover/Panel Bolt
    GM378543Courtesy of GENERAL MOTORS CORP.
  11. Disengage the panel fasteners in order to remove the rear cardboard panel.
  12. Unclip the head restraint retainers. Refer to Head Restraint Retainer Replacement - Front Seat .
  13. Remove the bolts which retain the seat belt tower cover.
    14. Fig 4: Locating Retractor Tower Retaining Screw
    GM381472Courtesy of GENERAL MOTORS CORP.
  14. Remove the seat belt tower cover.
  15. Pull the seat belt and the seat belt bezel through the opening in the seat cover.
  16. Lift the remainder of the seat back cover off the foam pad.
  17. Carefully remove the foam pad from the frame.
scientia non olet · About LEMON Manuals