LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Front (Manual) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat from the vehicle. Refer to Seat Replacement - Front Bucket .
  2. Remove the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  3. Remove the seat cushion frame. Refer to Seat Cushion Frame Replacement - Front .
  4. Remove the seat back frame. Refer to Seat Back Frame Replacement - Front .
  5. Remove the seat back hinge/recliner mechanism. Refer to Seat Back Hinge/Recliner Mechanism Replace - Front .
  6. Remove the seat adjuster track cover. Refer to Seat Adjuster Track Cover Replacement - Front .
    7. Fig 1: View Of Seat Belt Buckle, Nut & Electrical Connection
    GM381486Courtesy of GENERAL MOTORS CORP.
  7. Remove the inboard seat belt buckle and nut (1).

    Disconnect the electrical connection (2).

    8. Fig 2: EZ Entry Rod, Cross Brace & Bar
    GM396777Courtesy of GENERAL MOTORS CORP.
  8. Remove the bar (1) from the adjuster tracks (2). Straighten the tabs in order to remove the bar.
  9. Remove the cross brace (3).
  10. Remove the EZ entry rod (4), if equipped with the EZ entry feature.
  11. Remove the cushion tilt mechanism, if equipped.
scientia non olet · About LEMON Manuals