LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Seat Adjuster Replacement - Front (Manual) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cushion tilt mechanism, if equipped.
    2. Fig 1: EZ Entry Rod, Cross Brace & Bar
    GM396777Courtesy of GENERAL MOTORS CORP.
  2. Install the EZ entry rod (4), if equipped with the EZ entry feature.
  3. Install the cross brace (3).
  4. Install the bar (1) onto the racks (2). Bend the tabs in order to secure the bar.
    5. Fig 2: View Of Seat Belt Buckle, Nut & Electrical Connection
    GM381486Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  5. Install the inboard seat belt buckle and nut (1).

    Tighten:  Tighten the nut to 53 N.m (39 lb ft).

  6. Connect the electrical connection (2).
  7. Install the seat adjuster track cover. Refer to Seat Adjuster Track Cover Replacement - Front .
  8. Install the seat back hinge/recliner mechanism. Refer to Seat Back Hinge/Recliner Mechanism Replace - Front .
  9. Install the seat back frame. Refer to Seat Back Frame Replacement - Front .
  10. Install the seat cushion frame. Refer to Seat Cushion Frame Replacement - Front .
  11. Install the seat trim panel. Refer to Trim Panel Replacement - Front Seat .
  12. Install the front seat in the vehicle. Refer to Seat Replacement - Front Bucket .
scientia non olet · About LEMON Manuals