LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Lumbar Replacement - Front Seat (Power Lumbar/Bolster) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat from the vehicle. Refer to Seat Replacement - Front Bucket .
  2. Remove the head restraint and guides. Refer to Head Restraint Replacement (Non-Cadillac)  or Head Restraint Replacement (Cadillac)  or Head Restraint Replacement (Folding) .
  3. Remove the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
    4. Fig 1: Bolster Paddles
    GM385757Courtesy of GENERAL MOTORS CORP.
  4. Drill out the rivet holes on the bolster paddles (1).
    5. Fig 2: Removing Lumbar Wire
    GM381500Courtesy of GENERAL MOTORS CORP.
  5. Detach the lumbar clip from the top of the seat frame.
  6. Remove the lumbar wire from the bottom of the seat frame.
  7. Disconnect the electrical connectors to the motors.
  8. Remove the power lumbar/bolster assembly from the seat.
scientia non olet · About LEMON Manuals