LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Head Restraint Retainer Replacement - Front Seat >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slide up the seat back trim cover in order to gain access to the rear cardboard panel fasteners. Refer to Seat Back Cover and Pad Replacement - Front .
    2. Fig 1: View Of Seat Belt Tower Cover/Panel Bolt
    GM378543Courtesy of GENERAL MOTORS CORP.
  2. Remove the panel fasteners. Pull back the panel in order to gain access to the bushings.
    3. Fig 2: Removing Head Restraint Retainers
    GM409498Courtesy of GENERAL MOTORS CORP.
  3. Remove the head restraint retainers from the seat back frame by squeezing the retaining tabs together at the base of the guide(s) and lifting up.
scientia non olet · About LEMON Manuals