LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Head Restraint Retainer Replacement - Front Seat >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Head Restraint Retainers
    GM409498Courtesy of GENERAL MOTORS CORP.
  1. Install the head restraint retainers by pressing into the seat back frame until the retaining tabs snap into place at the bottom of the frame opening.
    2. Fig 2: View Of Seat Belt Tower Cover/Panel Bolt
    GM378543Courtesy of GENERAL MOTORS CORP.
  2. Position the cardboard panel to the seat back frame and install the panel fasteners.
  3. Install the seat back trim cover. Refer to Seat Back Cover and Pad Replacement - Front .
scientia non olet · About LEMON Manuals