LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Head Restraint Replacement (Cadillac) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Head Restraint Access Hole
    GM756156Courtesy of GENERAL MOTORS CORP.
  1. Install the head restraint by pushing down on restraint until the restraint is fully seated.
  2. To ensure the head restraint is fully seated pull the head restraint up to the full upward position.

    The head restraint must not come off the restraint rod.

scientia non olet · About LEMON Manuals