LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Armrest Replacement - Rear Seat (Bucket) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the clip in the slot of the seat frame.
  2. Install the rubber band on the clip to retain it in place.
  3. Fold down the seat cover.
    Fig 1: Rear Seat Armrest (60/40 - 50/50 Split)
    GM749102Courtesy of GENERAL MOTORS CORP.
  4. Install the arm rest by pressing in until it is fully seated.
  5. Connect the heating element wire connector.
  6. Pull down on the seat cover in order to install the 2 push pins retaining the seat back to the card board.
  7. Connect the J-clip at the bottom of the seat.
  8. Push on the seat back cover to ensure the cover is held in place by the velcro.
scientia non olet · About LEMON Manuals