LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Armrest Replacement - Front Seat >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the front seat back in the forward position.
  2. Separate the J-clip at the bottom of the seat using a flat bladed tool.
  3. Remove the 2 push pins at the bottom retaining the seat back cover to the card board.
  4. From the back of the front seat, disconnect the heating element wire connector, if equipped.
  5. Role up the seat cover up to the bottom of the arm rest.
  6. Recline the seat.
  7. From the front of the seat move the seat cushion away from the seat frame to gain access to the arm rest clip.
    Fig 1: Removing Front Seat Armrest Components
    GM749102Courtesy of GENERAL MOTORS CORP.
  8. Remove the rubber band from the clip.
  9. Remove the clip from the seat frame.
  10. Remove the arm rest by pulling outwards.
scientia non olet · About LEMON Manuals