LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Wiring Harness Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Wheel Wiring Harness
    GM780096Courtesy of GENERAL MOTORS CORP.
  1. Remove the steering wheel shroud. Refer to Steering Wheel Shroud Replacement .
    2. IMPORTANT: Note the steering wheel wiring harness routing during removal to insure proper installation.
  2. Disconnect the steering wheel wiring harness from the control switch.
  3. Remove the steering wheel wiring harness from the steering wheel.
scientia non olet · About LEMON Manuals