LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. Refer to Steering Wheel Replacement .
    2. Fig 1: View Of Horn Plunger At Steering Column
    GM399638Courtesy of GENERAL MOTORS CORP.
  2. Remove the horn switch from the steering wheel.
    3. Fig 2: View Of Shroud & Screws
    GM755486Courtesy of GENERAL MOTORS CORP.
  3. Remove the steering wheel shroud retaining screws from the back of the steering wheel.
  4. Remove the steering wheel shroud from the steering wheel.
    5. Fig 3: Steering Wheel Control Switch Mounting Screws
    GM408596Courtesy of GENERAL MOTORS CORP.
  5. Remove the steering wheel control switch mounting screws.
    6. Fig 4: Steering Wheel Control Switch & Electircal Connector
    GM780085Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the steering wheel control switch (2) electrical connector (1).
    7. Fig 5: Steering Wheel control Switch
    GM408598Courtesy of GENERAL MOTORS CORP.
  7. Remove the steering wheel control switch from the steering wheel.
scientia non olet · About LEMON Manuals