Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Steering Wheel control Switch

Courtesy of GENERAL MOTORS CORP.

Install the steering wheel control switch to the steering wheel.

Fig 2: Steering Wheel Control Switch Mounting Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the steering wheel control switch mounting screws.
Tighten: Tighten the mounting screws to 2 N.m (20 lb in).

Fig 3: Steering Wheel Control Switch & Electircal Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector (1) to the steering wheel control switch.

Fig 4: View Of Horn Plunger At Steering Column

Courtesy of GENERAL MOTORS CORP.

Install the horn switch to the steering wheel.
Tighten: Tighten the steering wheel horn switch to 5.5 N.m (50 lb in).
Install the steering wheel. Refer to Steering Wheel Replacement .