LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Trim Covers - Disassemble - Off Vehicle (Floor Shift)

Steering Column Trim Covers - Disassemble - Off Vehicle (Floor Shift)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Trim & Pan Head Tapping Screws
    GM415298Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR CAUTION in Cautions and Notices.
  1. Disable the inflatable restraint steering wheel module. Refer to DISABLING SYSTEM in SIR.
  2. Remove the steering wheel from the column. Refer to Steering Wheel Replacement .
  3. Remove the tilt lever from the lower trim cover. Refer to Tilt Lever Replacement - On Vehicle .
  4. Remove the 2 pan head tapping screws (1) from the lower trim cover (2).
    5. Fig 2: View Of Lower And Upper Steering Column Covers
    GM328807Courtesy of GENERAL MOTORS CORP.
  5. Remove the lower trim cover from the upper trim cover by performing the following steps:
    1. Tilt the lower trim cover down.
    2. Slide the lower trim cover backward in order to disengage the locking tabs.
    6. Fig 3: Upper Trim Cover & Screws
    GM415299Courtesy of GENERAL MOTORS CORP.
  6. Remove the 2 TORX® head screws (1) from the upper trim cover (2).
  7. Remove the upper trim cover (2) from the steering column.
scientia non olet · About LEMON Manuals