Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Seal On The Shift Lever And TORX Head Shift Lever Screw (With Tow/Haul Switch)

Courtesy of GENERAL MOTORS CORP.

Install the shift lever (1).

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the TORX® head screw (2).
Tighten: Tighten the screw to 1.5 N.m (13 lb in).
Roll the seal over the TORX® head screw (2).