LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Linear Shift Assembly - Assemble - Off Vehicle (Column Shift)

Linear Shift Assembly - Assemble - Off Vehicle (Column Shift)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Linear Shift Assembly And Retaining Screws
    GM662202Courtesy of GENERAL MOTORS CORP.
  1. Install the linear shift assembly onto the steering column support assembly.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Secure the linear shift assembly to the steering column assembly with the 3 flat head tapping screws.

    Move the linear shift assembly out of the PARK position to install the lower socket tapping screw.

    Tighten:  Tighten the 3 TORX® screws to 10 N.m (89 lb in).

    3. Fig 2: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS CORP.
  3. Install the automatic transmission shift lock control.
  4. Install the shift lever clevis and put the column in the neutral position.
  5. The neutral position is 2 positions from the park position.
    6. Fig 3: Park Position Switch
    GM662195Courtesy of GENERAL MOTORS CORP.
  6. Slide the park position switch assembly onto the linear shift assembly.
  7. Connect the automatic transmission shift lock control connector onto the park position switch assembly.
    8. Fig 4: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
  8. Connect the park lock cable assembly (1) to the lock module assembly in the following way:
    1. Place the steering column lock cylinder set into the off position.
    2. Place the shift lever clevis into the park position.
    3. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the lock module assembly.
  9. Install the shift lever. Refer to Shift Lever Replacement - On Vehicle (With Tow/Haul Switch)  or Shift Lever Replacement - On Vehicle (Without Tow/Haul Switch) .
  10. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift Snap On Shrouds)  or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) .
  11. Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM in SIR.
scientia non olet · About LEMON Manuals