LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Horn Switch Replacement - On Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Horn Plunger At Steering Column
    GM399638Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SERVICING THE SIR SYSTEM CAUTION in Cautions and Notices.
  1. Disable the SIR system. Refer to DISABLING SYSTEM in SIR.
  2. Remove the Inflatable Restraint Steering Wheel module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) in SIR.
  3. Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.
    4. Fig 2: View of Horn Contact Plate, Steering Wheel & Screws
    GM776565Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the horn contact plate (2) captured screws (1,4) from the steering wheel (3).
  5. Remove the horn switch (2) from the steering wheel (3).
scientia non olet · About LEMON Manuals