LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Electronic Column Lock Module - Assemble - Off Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lock Cylinder Housing TORX Screws
    GM1413838Courtesy of GENERAL MOTORS CORP.
  1. Install 3 TORX® screws into the lock cylinder housing.

    Tighten:  Tighten the TORX® screws to 7N.m(62 lb in).

  2. Install the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle .
  3. Install the park lock cable into the lock cylinder housing.
  4. Install the ignition switch. Refer to Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle .
  5. Enable the SIR system. Refer to ACTIVATING SYSTEM in SIR.
scientia non olet · About LEMON Manuals