LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Interior Trim) >> Repair Instructions >> Assist Handle Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Rear Assist Handle
    GM662475Courtesy of GENERAL MOTORS CORP.
  1. Install the assist handle to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the assist handle screws.

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

  3. Install the center pillar trim panel. Refer to Garnish Molding Replacement - Center Pillar  .
scientia non olet · About LEMON Manuals