LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 681 (Parking Brake System) >> Repair Instructions >> Park Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the front park brake cable to the park brake lever.
  2. Install the park brake lever.
  3. Install the MID-Bussed Electrical Center bracket.
  4. Install the park brake lever mounting nuts. Tighten the nuts to 25 N.m (18 lb ft).
  5. Raise the vehicle.
  6. Support the vehicle with safety stands.
  7. Install the rear cables to the equalizer by pulling down on the intermediate cable and install the rear cables to the equalizer bar.
  8. Remove the safety stands.
  9. Lower the vehicle.
  10. Connect the park brake release cable to the park brake lever.
  11. Connect the park brake warning lamp connector.
  12. Install the left side hinge pillar panel.
  13. Install the left side kick panel.
  14. Connect the negative battery cable.
scientia non olet · About LEMON Manuals