LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 681 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Replacement - Right Rear (With RPO NYS) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new brake cable (2) into the rear brake cable mounting bracket (3) by pushing the cable into place until the locking tabs (1) snap into place.
  2. Install the park brake cable to the lever.
  3. Install the rear park brake cable bracket bolt. Tighten the rear park brake cable bracket bolt to 61 N.m (45 lb ft).
  4. Install the park brake cable to the differential clip.
  5. Install the park brake cable bolt to the rear axle clip. Tighten the park brake cable bolt to 25 N.m (18 lb ft).
  6. Install the park brake cable taking care to correctly route the cable though the guides and the body mounts.
  7. Install the park brake cable into the mounting bracket until the locking tabs snap into place.
  8. Install the park brake cable to the equalizer bar.
  9. Remove the safety stands.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals