LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 681 (Parking Brake System) >> Repair Instructions >> Park Brake Cable Mounting Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cable support bracket.
  2. Install the cable support bracket nuts. Tighten the support bracket nuts to 85 N.m (64 lb ft).
  3. Install the rear cables to the mounting bracket by inserting the cable till all the retaining tabs snap into place.
  4. Connect the rear cables to the equalizer.
  5. Tighten the nut to the intermediate cable at the equalizer. Tighten the nut to 3.5 N.m (31 lb in).
  6. Remove the safety stands.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals