Installation Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra, 2002 GMC Cab & Chassis Sierra, 2002 Chevrolet Silverado, and 2002 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the park brake actuator lever housing to the backing plate.
- Perform the following procedure before installing the backing plate bolts.
- 2.1. Remove all traces of the original adhesive patch.
- 2.2. Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
- 2.3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
- Install the backing plate bolts. Tighten the backing plate bolts to 135 N.m (100 lb ft).
- Install the park brake shoe. Refer to Park Brake Shoe Replacement (Except RPO NYS, 25/35 Series) or Park Brake Shoe Replacement (25/35 Series) .
- Install the axle shaft.
- Adjust the park brake shoe. Refer to Park Brake Adjustment .
- Install the rotor. Refer to BRAKE ROTOR .
- For vehicles without RPO NYS, install the park brake cable to the mounting bracket until the locking tabs snap into place
- For vehicles with RPO NYS, install the rear park brake bracket bolt. Tighten the bolt to 61 N.m (45 lb ft).
- Install the rear park brake cable to the park brake actuator lever.
- Install the rear cables to the rear cables to the equalizer by pulling down on the intermediate cable and install the rear cables to the equalizer bar.
- Install the tire and wheel assembly.
- Remove the safety stands.
- Lower vehicle.
- Adjust park brake cable. Refer to Park Brake Adjustment .